VW Crafter Workshop Manuals & Wiring Diagrams
Volkswagen Crafter Service and Repair Manual, color wiring diagrams, engine and transmission diagnostics, error codes, fuse locations. Crafter model: (SY,SZ) MAN TGE
Volkswagen LT3, Engines: 2.5 TDI CR, 2.0 TDI CR, 2.0 BiTDI CR.
The manual can be downloaded in PDF format for free.
The manual provides information on diagnostics, service procedures and specifications for your vehicle.
2.5L TDI EURO V Engines – Self-Study Programme 446 Download
Service Training, Design and function
Crafter Shiftmatic Gearbox 0B81 – Self-study Programme 372 Download
Hydraulics Electronics Service Test Yourself
2.5l TDI Engines in the Crafter – Self-study programme 371 Download
Engine, Functional diagram, Service manual, Engine mechanics
Crafter Electrical system – Self-study Programme 370 Download
electrical system, Ignition lock, Dash panel, Special control units, service manual
Crafter 2006 – Self-study Programme 369 Download
Body, Engines service, Transmission manual, Electrical system, Heating, air conditioning
2006-2016 Volkswagen Crafter Service & Repair Manuals
Volkswagen Crafter Maintenance
Guide for increasing and decreasing load ratings
5-cylinder diesel engine (Engine ID BJJ, BJK, BJL, BJM, CEBA, CEBB, CECA, CECB)
4-cylinder diesel engine (2L engine, CR) (Engine ID CKTB, CKTC, CKUB, CKUC, CSLB, CSNA, CSLA, CSLC)
Fuel supply system – Diesel engines
Shiftmatic automated gearbox 0B8
Rear axle and rear final drive
Wheels and Tyres Guide – General Information
General body repairs, exterior
General body repairs, interior
2006-2016 Volkswagen Crafter Wiring Diagram. Fuse box diagram
Volkswagen Crafter (SY,SZ) 2017-2020 Workshop Manuals
4-cyl. common rail (2.0l, 4V, turbocharger, transverse engine) (DAUB DAUA DAVA)
4-cyl. common rail (2.0l, 4V, turbocharger, inline engine) (DASA DASB DAWA DASC)
Fuel supply system – Diesel engines
Propshaft and rear final drive
Wheels and Tyres Guide – General Information
Factory-installed Accessories and Conversions
Guide for increasing and decreasing load ratings
Air conditioning systems with refrigerant R1234yf – General information
General information, Paint for commercial vehicles
Vehicle-specific paint information
General body repairs, exterior
(SY,SZ) 2017-2020 VW Crafter Wiring Diagram. Fuse box diagram
Volkswagen Crafter FAQ
When starting cold, the starter spins as it should, but will not start.
Possible reasons:
Perhaps the ignition is a little wrong (the belt was replaced) - Set the ignition.
It could be a problem with the check valve on the fuel filter. - check the pressure valve in the fuel rail.
the problem may be in the injectors (fuel is drained back)
Faulty camshaft sensor - diagnose / replace the sensor
Injection pump is clogged (during diagnostics, there should be an error "low fuel pressure") - after cleaning and flushing, the problem should disappear
Strong vibration of the engine during acceleration and does not go > 90 km / h
- Coolant can go into the EGR radiator and from there into the pipe
- Also, a crack often appears in the block in the region of the 5th cylinder, closest to the bumper.
- Replacing or checking the sensor on the filter housing may help. Also, the latch on the connector on this sensor breaks almost for everyone and there is no contact.
After replacing the timing, the engine began to work hard, when you sharply press the gas pedal, you can hear the crackling of the nozzles
- clean injection pump and valves
2014 Crafter, cku 2.0 engine. Where is the oil filter located?
- On a 2-liter engine, the filter is located behind the engine, it’s not realistic to see it only by touch, if you remove the air filter housing, then a motor will hang behind it on the stove nozzles, so put your hand under it and feel the filter cover. socket wrench 32
Volkswagen Crafter 2.0 diesel 143 hp station wagon, problem with the stove.
- If the temperature of the coolant jumps or rises to such limits up to 100C, then the first thing to do is to change the thermostat.
- Flush the cooling system
- Remove air from the system, an air lock is possible
- Change the cylinder head gasket (most often the problem is in it)
FOR RIGHT HOLDER
Attention! By clicking on the download link you agree, after reading, delete the downloaded file from your computer. All content on the site is taken from free sources and is also distributed free of charge. If you are the author of this material, then please contact us to provide users with a pleasant and convenient alternative after reading the purchase of a quality "original" directly from the publisher. The site administration is not responsible for illegal actions and any damage caused to copyright holders. All materials are posted on the site for information purposes. If you are the copyright holder of the materials posted on this site - contact us.
thomas schweizer (Thursday, 27 April 2023 16:52)
THX